8″ Solid Auger Assembly

Start with your application. We will use it to guide the assembly configuration.

AsphaltAn asphalt application follows the solid-auger path in this draft guide.✓ SelectedConcreteFor concrete, the next question checks whether you are placing rebar.✓ Selected

Measure the inside diameter—not the outside diameter. Follow the diagram above, measure again, then choose a listed size only if it matches your measurement.

The rebar requirement determines whether the guided configuration is hollow or solid.

Yes — Hollow auger requiredRebar passes through the curb. This guide selects a hollow configuration.✓ SelectedNo — Solid augerNo rebar is being placed in the curb. This guide selects a solid configuration.✓ Selected

Measure the inside diameter—not the outside diameter. Follow the diagram above, measure again, then choose a listed size only if it matches your measurement.

Measure the inside diameter—not the outside diameter. Place the measuring tool across the center of the opening, from one inside edge to the opposite inside edge. The tube wall is not part of this measurement. Diameter identifies the size; the application and approved mapping must also match.

Measure the inside diameter—not the outside diameter. Follow the diagram above, measure again, then choose a listed size only if it matches your measurement.